How to Do A Iron on Transfer

I found this todo online.  I'll post a pic. as soon as I can.

Supplies Needed: CriCut Design (Any cartridge), Color Fabric preferably light weight cotton, HeatnBond Ultra Adhesive, glitter t-shirt paint, spray glitter, and an Iron.

1. Cut your fabric to the desired size for your design.

2. Iron the Ultra bond onto the back side of the fabric as directed on the packaging. Let the fabric cool before continuing.

3. Peel away the protective wax paper, and save (it can be used to protect fabric from scorching in a future step).

4. Place the fabric onto a cutting mat. Be careful to make sure the fabric is smooth, and there are no bubbles or wrinkles. I used a clean brayer to roll over the fabric to insure it's smoothness.

5. Cut your pattern as you would if it were paper.

6. Place the design on your project, and replace the wax paper over the top of your design, and Iron it onto your project.

7. I sewed ribbon down the right side.

8. The Pennant was cut from a piece of stiff felt.

9. The stars were ready-made fun foam glitter covered stars.

10. The pom poms were created from fuzzy yarn.

11. The Megaphone was cut from red fabric by hand using a template.